Supplied in a one-wire hookup configuration enabling you to run a single wire from the alternator to the battery (positive). Hand polished and triple chrome plated to a mirror finish. Hand Polished and triple chrome plated to a mirror finish.Can be used in either 1 wire or 3 wire hookup configuration. Factory load tested and certified before being packed. Supplied and fitted complete with matching chrome alternator pulley.
Suitable to replace existing 1 wire, V-Belt type, internal regulator GM style alternator. Mounts measure approximately 18mm outside depth on the short side, 51mm outside depth on the long side. The measurement between the mounts from the inside edge, to inside edge is 159mm. The measurement between the mounts from the bolt centres is 6.60. Utilizes the the standard GM 10SI style case with 6.600 bolt centres.Total length from the front of the rotor shaft to the deepest point at the rear of the case is approximately 165mm. Please use the above measurements and information to compare to your original alternator, to ensure correct fitment for your vehicle. This item is in the category "Vehicle Parts & Accessories\Car & Truck Parts & Accessories\Starters, Alternators, ECUs & Wiring\Alternators & Generators". The seller is "tuffcarparts" and is located in this country: AU. This item can be shipped worldwide.